The Bells Of St. Mary's

A Taunton Community Project

Tuesday, 09 August 2016

3rd Casting -- 4 more

On Thursday 4th August 4 more bells were cast (2nd, 4th, 5# & 9th); just 4 left for 25th August! On this occasion the coach party from Taunton were able to see the Tenor still sitting on the lathe after tuning. Foundry comment 'sounds beautifull' and one of the visitors 'We actually heard it when 'donged' with a clapper, what an amazing moment!!!'

 ten2  ten1


Thursday, 04 August 2016

Working while 'We Wait'

Most of the project work is now taking place at the Foundry, but the 'Team' is still busy at home. The electrician has almost completed rewiring and new LED lighting of the stairway while clearing and cleaning has been done from top to bottom.

 clean1 clean2

clean3 clean4

Friday, 22 July 2016

Casting of 4 more

Thursday 21st July was the day when the second batch of 4 bells (3rd, 6th, 8th & 11th) were cast. Another coach with many Taunton Branch members were able to watch the Branch (Annie's Ride, 11th) Bell being poured. The 6b from the previous cast can be seen at the back of photo 3, below.


Tuesday, 28 June 2016

Casting begins

Thursday 23rd June was the beginning of the rebuild phase of our project. The first three bells; 6b, 9# and Tenor (Somerset Bell) were cast at Loughborough. A coach with ringers, vicar, members of St. Mary's congregation and the Mayor of Taunton Deane were given a conducted tour of the Museum and foundry works before the casting. The ringers then spent 45 mins. on the foundry bells. The other bells will be cast over the next two months.

     The Old Bells                                                   Group outside the Museum

Bells Group

Saturday, 14 May 2016

13 May 2016 -- End of phase one

An early start saw the lorry loaded by mid-morning, the last bell being the 11th (Bilbie) oldest and arguably the best, which may end up in Australia. Finally the electric hoist was lowered on double chain blocks and all equipment repacked on the Foundry van. Another van load of nuts, bolts and grillage iron went to the scrap yard before lunch. Plywood & Chipboard (used to protect the floor and Angel doors) was stored in the Vicarage garage for future use and a good vacuum saw the West entrance ready for public use again on Saturday morning.

Another phase of the project has come to a successful conclusion (with only the loss of one mug of tea & the broken mug!).

 bilbie frames

head loaded2

electric workhorses